Comtech EF Data ODM-840 - Manual (Page 110)

ODM/R-840 Outdoor Remote Router Revision 0
Ethernet-based Remote Product Management MN-ODM840
5–22
• Line Coding – Use the drop‐down menu to select this parameter as HDB3 or AMI.
• WAN Loopback / Terrestrial Loopback – Use the drop‐down menus to set these parameters
as either Disable or Enable.
Click [Submit] to save any changes made to the E1 Configuration settings.
RAN Optimization
Appendix C. RAN/WAN OPTIMIZATION
Use RAN Optimization to reduce the satellite bandwidth required for mobile backhaul. Use this
section to select the level of optimization needed to achieve the desired link quality and
bandwidth savings.
• Hub RAN Optimizier IP Address – Enter an IP address in the form XXX.XXX.XXX.XXX.
• Hub RAN Optimization E1 Port ID – Enter an numeric identification string for the ‘G.703 | IN
/ OUT’ port pair, corresponding to a specified, corresponding port on the CXU‐810 RAN
Optimizer.
• Optimization Level – Use the drop‐down menu to set this parameter as Best Performance
or Best Compression.
• Jitter Buffer Latency – Use the drop‐down menu to set this parameter as 10ms, 20ms,
30ms, 40ms, or 50ms.
• Alarm Relay – Use the drop‐down menu to select as Disable or Enable. Selecting Enable will
both trigger the logging of operational faults or alarms on the Status | Statistics | E1 |
Transmit / Receive pages and toggle the STORED EVENT LED on the front panel on.
Click [Submit] to save any changes made to the RAN Optimization settings.
E1 Port
By default, access to G.703 Clock Extension operation defaults to Enabled when this FAST option
is activated. Use this section to otherwise disable G.703 Clock Extension operations.
Use the E1 Port drop‐down menu to select Disable. Click [Submit] to save this configuration.