Comtech EF Data ODM-840 - Manual (Page 138)

ODM/R-840 Outdoor Remote Router Revision 0
Ethernet-based Remote Product Management MN-ODM840
5–50
current conditions. Note that this value must be less than the value specified for the SCPC
Step Up Threshold. The valid range is from 0 to 100%. A typical setting for this parameter is
65%.
• Delay – Enter the Switching Delay period, in seconds, to ensure that a premature switch up
or down in the SCPC rate does not occur due to a temporary rise or fall in traffic. The valid
range is from 1 to 50 seconds.
• Excess Capacity – Enter the Excess Capacity data rate value (percentage) to be added to the
SCPC data rate. This setting makes additional bandwidth available for when demand arises
while minimizing Step Up switching events. The valid range is from 0 to 100%.
ToS Switching Configuration
• Enable – Use the drop‐down menu to select operation as Disabled or Enabled.
• Max # of Sessions (per ToS Id) (1‐127) – Allows setting a limit for the number of active
sessions for a particular ToS switch type. Note that the overall limit for active sessions in the
network is 127.
Click [Submit] to save these settings.
A ToS Rules Table is provided in this section. From left to right:
• Index – The automatically‐assigned specific rule internal index number is identified here.
• Name – Enter a text label for circuit identification. The valid range is from 1 to 20 characters.
• ID – Enter an integer value, in the range from 1 to 63, for the ToS ID.
• Type – Enter an integer value, in the range from 64 to 254, for the Switch Type to inform the
VMS what switching policy to use.
• SCPC Data Rate – Enter the desired data rate, in kbps, for this service type. The valid range is
from 16 to 16000 kbps.
• Timeout – Enter the timer setting for restoring home state condition when data packet flow
stops for this duration. The valid range is from 0 to 60.
To edit a ToS Switching Configuration rule:
Edit the information for the specific indexed rule. Click [Change] when done.
To delete a ToS Switching Configuration rule:
Click [Delete] to delete the specific indexed rule from the ToS Rules Table.