Comtech EF Data ODM-840 - Manual (Page 105)

ODM/R-840 Outdoor Remote Router Revision 0
Ethernet-based Remote Product Management MN-ODM840
5–17
5.4.4.2.6 Admin | VMS
The VMS page is operational only when the optional VIPERSAT MANAGEMENT
SYSTEM (VMS) is installed and operational.
VMS v3.x.x VIPERSAT Management System User Guide (CEFD P/N MN/22156)
Figure 6‐8. Admin | VMS page
Vipersat Management System Configuration
The acceptable/valid operating ranges for items in this section are provided in parentheses.
• Network ID (1‐254) – The Network ID is used by the VMS to identify Vipersat units within a
network and allows the VMS to manage multiple networks, each with its own unique
Network ID number. All devices in a common network will have the same Network ID. This
designation defines to which network this ODM/R‐840 belongs.
• Management Base Port – The Management Base Port sets the starting IP port addressing
for all VMS messages.
Use this setting ONLY if network port addressing is in contention. Changes to
this address base affect the entire network, requiring configuration changes to
all modems (i.e., the “hub” CDM‐800 Gateway Router and the “spoke”
CDM‐840 Remote Router). Leave this setting at the default value of 49152 (hex
C000) to avoid unnecessary configuration changes.