Comtech EF Data ODM-840 - Manual (Page 52)

ODM/R-840 Outdoor Remote Router Revision 0
Installation MN-ODM840
3–2
3.2 Preparing for ODM/R-840 Standalone Installation
The ODM/R‐840 Outdoor Remote Router is constructed as a fully‐contained, weatherproof
chassis intended for field installations.
“Standalone” as used in this chapter refers to the mounting of a single ODM/R‐840 Outdoor
Remote Router, or a single ODMR‐840 Reduced Form Factor Outdoor Remote Router and its
separate ODMR‐PS Power Supply module, to a satellite antenna support pole. The equipment
can also be free‐standing if desired. Cables are then connected for non‐redundant operation.
Comtech EF Data recommends that, at a minimum, the following tools are used to install any
ODM/R‐840 Standalone configuration:
• Adjustable wrench
• English unit box or socket wrenches (hex nuts and hex head bolts are used)
• Medium Phillips™ screwdriver (Phillips‐head screws are used)
• Tin snips