Comtech EF Data ODM-840 - Manual (Page 135)

ODM/R-840 Outdoor Remote Router Revision 0
Ethernet-based Remote Product Management MN-ODM840
5–47
5.4.4.3.10 Configuration | ECM (Entry Channel Mode)
This page is operational only when the optional dSCPC FAST feature and VIPERSAT
MANAGEMENT SYSTEM (VMS) is installed and enabled.
Appendix G. ENTRY CHANNEL MODE SWITCHING in the VMS v3.x.x VIPERSAT
Management System User Guide (CEFD P/N MN/22156)
Use this page to configure ECM (Entry Channel Mode). ECM provides a method for remotes
requiring dSCPC access channels to either enter the network initially or re‐enter the network
after a power or service outage.
Figure 6‐25. Configuration | ECM page
ECM Remote Configuration
• Mode – Use the drop‐down menu to select operation as Disabled, Offline, Wait, or Online.
Click [Submit] when done.
• Multicast IP – Enter the IP address for the Multicast of the Transmission Announcement
Protocol (TAP) message that is sent out by the CDD‐880 Multi Receiver Router to all of the
associated ODM/R‐840 Remote Routers in that group.