Comtech EF Data ODM-840 User Manual
Page 133
ODM/R-840 Outdoor Remote Router
Revision 0
Ethernet-based Remote Product Management
MN-ODM840
5–45
Set the desired BUC configurations. Click [Submit BUC Control] to save.
BUC Status
BUC Power Supply, BUC Voltage (V), and BUC Current (mA) – When the presence of BUC Power
Supply is detected, it is acknowledged here and its voltage and current information is
continuously monitored and is provided on a read‐only basis.
Click [Refresh] to update this section with its latest available statistics.
5.4.4.3.9
Configuration | LNB (Low Noise Block Downconverter)
This page is operational only when an optional LOW‐NOISE BLOCK DOWNCONVERTER is
installed.
Use this page to configure Low‐Noise Block Downconverter parameters, and to display the LNB
status for L‐Band operation.
Figure 6‐24. Configuration | LNB page
LNB Control
The acceptable/valid operating range for each item in this section is provided in parentheses.
• LNB Frequency (3000‐65000) – Enter a value (in MHz) for the LNB Frequency.
• Rx LO Frequency – Use the drop‐down menu to designate the Rx Local Oscillator Frequency
as a HIGH (+) or LOW (‐) limit.