Comtech EF Data ODM-840 - Manual (Page 107)

ODM/R-840 Outdoor Remote Router Revision 0
Ethernet-based Remote Product Management MN-ODM840
5–19
5.4.4.3 Configuration Pages
The BUC and LNB tabs are available ONLY when those optional products are
installed and operational.
Use the nested ‘Configuration’ pages to configure all unit parameters. Dependent on
availability, click the Interface, Demod, Mod, ARP, Routing, Compression, WAN, BUC, LNB,
ECM, or dSCPC tab to continue.
5.4.4.3.1 Configuration | Interface pages
Click the MGT/Traffic or E1 tab to continue.
5.4.4.3.1.1 Configuration | Interface | Mgt/Traffic
As a router, FE and GigE must be on different subnets.
Use this page to configure the ‘ETHERNET T/M’ port.
Figure 6‐9. Configuration | Interface | FE Mgt page
FE – Management Interface
• MAC Address – The MAC Address is read‐only and cannot be changed.
• IP Address / CIDR Mask – Use this box to enter the IP Address and CIDR (Classless Inter‐
Domain Routing) Subnet Mask. The valid range for the Subnet Mask is from 8 to 30.