Comtech EF Data ODM-840 User Manual
Page 137
ODM/R-840 Outdoor Remote Router
Revision 0
Ethernet-based Remote Product Management
MN-ODM840
5–49
5.4.4.3.11
Configuration | dSCPC (Dynamic Single Carrier per Channel)
This page is operational only when the optional dSCPC FAST feature and VIPERSAT
MANAGEMENT SYSTEM (VMS) is installed and enabled.
The optional dSCPC (Dynamic Single Carrier per Channel) FAST feature is used to enable dynamic
allocation and sharing of bandwidth among users. Use this page to configure dSCPC operation.
Figure 6‐26. Configuration | dSCPC page
Load Switching Configuration
• Mode – Use the drop‐down menu to select operation as Disabled or Enabled. Click [Submit]
when done.
• Step Up Threshold – Enter the percentage of bandwidth use that will trigger a switch up
from the present SCPC rate to a higher rate to ensure that there is sufficient bandwidth
available for current conditions. Note that this value must be greater than the value
specified for the SCPC Step Down Threshold. The valid range is from 0 to 100%. A typical
setting for this parameter is 95%.
• Step Down Threshold – Enter the percentage of bandwidth use that will trigger a switch
down from the present SCPC rate to a lower rate to ensure efficient bandwidth usage for