Basler Electric DGC-2020ES - Manual (Page 247)

9469200990 Rev C 239
Revision History
Table 38 provides a historical summary of the changes made to the DGC-2020ES hardware. Firmware
changes are listed in Table 39 and software changes are listed in Table 40. The corresponding revisions
made to this instruction manual are summarized in Table 41. Revisions are listed in chronological order.
Table 38. Hardware Revision History
Hardware
Version and Date
Change
A, 03/13
•
Initial release
B, Jun-13 •
Maintenance release
C, Apr-14 •
Released firmware version 1.01.00
D, May-14
•
Released firmware version 1.01.01
E, Nov-14 •
Released firmware version 1.02.00 and BESTCOMSPlus 3.07.00
Table 39. Firmware Revision History
Firmware
Version and Date
Change
1.00.00, Mar-13
•
Initial release
1.01.00, Jan-14 •
Changed to make horn always sound for pre-alarm after alarm
silence button is pressed
•
Extended minimum range of Low Coolant Temp Pre-alarm down
to 0 degrees F
•
Changed to prevent default run statistics after firmware upload
•
Modified Diesel Particulate Filter Soot Level and Regeneration
Required Status Information to use the Diesel Particulate Filter
Status parameter (SPN 3701)
•
Added a one-line diagram to the Front-Panel Overview screen
•
Improved the Event Log
•
Increased number of events to 50
•
Added Scania Engine ECU support
•
Added Diesel Exhaust Fluid Level on Overview screen on systems
which have Selective Catalytic Reduction with Diesel Exhaust
Fluid implemented
•
Added Diesel Exhaust Fluid Tank Level and Percent kW Load to
Configurable Metering
•
Modified Cummins Proprietary J1939 communications to support
Cummins QSX-15 model and run at RPM selected under Speed
Setup
•
Modified Volvo Proprietary J1939 communications to support RPM
selection
•
Added ATS Programmable Function Setting to HMI
•
Removed Contact Input Recognition Parameter as a setting for the
ATS Programmable Function
•
Removed Contact Input Recognition Parameter as a setting for the
Low Coolant Level, Batt Charger Fail, and Fuel Leak Detect
Programmable Functions
•
Removed Contact Input Recognition Parameter as a setting for the
Low Fuel Level Programmable Function
DGC-2020ES Revision History