Basler Electric DGC-2020ES - Manual (Page 213)

9469200990 Rev C 205
Fault
Code
Number
String Description
485 SS T EXHAUST C High Exhaust C Temperature (Limit 2).
486 HI T EXHAUST D High Exhaust D Temperature.
487 SS T EXHAUST D Shutdown due to High Exhaust D Temperature.
488 HI ETC 3 OVERSPD High Turbo Charger ETC 3 Overspeed (Limit 1).
489 SS ETC 3 OVERSPD High Turbo Charger ETC 3 Overspeed (Limit 2).
490 HI ETC 4 OVERSPD High Turbo Charger ETC 4 Overspeed (Limit 1).
491 SS ETC 4 OVERSPD High Turbo Charger ETC 4 Overspeed (Limit 2).
492 HI ETC 4 CUTIN FAIL High Turbo Charger ETC 4 Cut In Failure (Limit 1).
493 HI ETC 3 CUTIN FAIL High Turbo Charger ETC 3 Cut In Failure (Limit 2).
494 SD THROTL A FDBK Sensor Defect In Throttle A Feedback Sensor.
495 SD THROTL B FDBK Sensor Defect In Throttle B Feedback Sensor.
496 SD P CHARGE MIX A Sensor Defect In Charge Mix A Pressure Sensor.
497 SD P CHARGE MIX B Sensor Defect In Charge Mix B Pressure Sensor.
498 SD P CHRG MIX DIFF Sensor Defect In Charge Mix Differential Pressure Sensor.
499 SD P CHARGE MIX Sensor Defect In Charge Mix Pressure Sensor.
500 AL WIRING POM STARTER
1 A wiring fault has been detected in the connection of starter 1 of POM.
501 AL WIRING POM STARTER
2 A wiring fault has been detected in the connection of starter 2 of POM.
502 AL OPEN LD POM
ALTRNATR An open load on POM’s alternator output has been detected.
503 AL BATT NOT CHARGING Battery is not being charged by alternator.
504 AL CAN POM NODE LOST POM is missing on CAN bus.
505 AL NEW POM FOUND New POM found.
506 AL LOW STARTER VOLTS Battery voltage is too low for starting.
507 AL POM ERROR A general POM error has been detected.
508 AL WRONG POM ID POM sends a different identification number (ID) than expected.
509 AL CHECK POM FUSE Check POM fuse.
510 AL OVERRIDE APPLIED Override applied.
511 HIHI P CHG MIX A Hi Charge Air Mix A Pressure (Limit 2).
512 HIHI P CHG MIX B Hi Charge Air Mix B Pressure (Limit 2).
513 SD P COOLNT DIFF Sensor Defect In Coolant Differential Pressure Sensor.
514 WRITE ERR FLASH Write Error Occurred when writing data to Flash Memory.
515 STARTER NOT ENGAGED Starter of POM could not be engaged.
516 OILNIVEAU CAL ERR Remote Oil Level Watchman Calibration Error.
517 SD CHG MX PR THRT Sensor Defect In Charge Pre-Throttle Mix Pressure Sensor.
518 SD THROT BYPASS FDBK Sensor Defect In Throttle Feedback Bypass Sensor.
519 OIL LVL CAL ERROR Oil Level Calibration Error.
520 SD P IN AIR AFT FLT A Sensor Defect In Intake Air After Filter A Pressure Sensor.
521 SD P OIL MID VAL Lube Oil Pressure Middle Value (Limit 2).
522 SD P IN AIR AFT FLT B Sensor Defect In Intake Air After Filter B Pressure Sensor.
523 SD T COOL RED MIDVL Coolant Temperature Mid value (Limit 2).
524 SS ENG OVRSPD MIDVL Engine Speed Middle Value too high (Limit 2).
525 SD P LUBE OIL R2 Sensor Defect In Lube Oil Pressure (R2) Sensor.
526 SD T COOL OIL R2 Sensor Defect In Oil Coolant Temperature (R2) Sensor.
527 TD ENG SPD SNS DEV Engine Speed Sensor Deviation.
528 SD ENG SPD SENSR 3 Sensor Defect in Engine Speed Third Sensor.
DGC-2020ES MTU Fault Codes