Basler Electric DGC-2020ES - Manual (Page 190)

182 9469200990 Rev C
Radio Interference
Type tested using a 5 W, hand-held transceiver operating at random frequencies centered around 144
and 440 MHz with the antenna located within 150 mm (6”) of the device in both vertical and horizontal
planes.
HALT (Highly Accelerated Life Testing)
HALT is used by Basler Electric to prove that our products will provide the user with many years of
reliable service. HALT subjects the device to extremes in temperature, shock, and vibration to simulate
years of operation, but in a much shorter period span. HALT allows Basler Electric to evaluate all possible
design elements that will add to the life of this device. As an example of some of the extreme testing
conditions, the DGC-2020ES was subjected to temperature tests (tested over a temperature range of
–100
°C to +130°C),
vibration tests (of 5 to 50 G at +20
°C), and temperature/vibration tests (tested at 50 G
over a temperature range of –95
°C to +125°C). Combined temperature and vibration testing at these
extremes proves that the DGC-2020ES is expected to provide long-term operation in a rugged
environment. Note that the vibration and temperature extremes listed in this paragraph are specific to
HALT and do not reflect recommended operation levels.
Ignition System
Tested in close proximity to an unshielded, unsuppressed Altronic DISN 800 Ignition System.
Environment
Operating Temperature .................... –40 to +70
°C (–40 to +158°F)
Storage Temperature ....................... –40 to +85
°C (–40 to +185°F)
Humidity ........................................... IEC 68-2-38
Salt Spray ......................................... IEC 68-2-52
Ingress Protection ............................ IEC IP56 for front panel
UL Approval
The DGC-2020ES is recognized to applicable Canadian and US safety standards and requirements by
UL.
Standards used for evaluation:
•
UL6200
•
CSA C22.2 No. 14
CSA Certification
The DGC-2020ES was tested and has met the certification requirements for electrical, plumbing and/or
mechanical products.
Standards used for evaluation:
•
CSA C22.2 No. 14
NFPA Compliance
Complies with NFPA Standard 110, Standard for Emergency and Standby Power.
CE Compliance
This product has been evaluated and complies with the relevant essential requirements set forth by the
EU legislation.
Specifications DGC-2020ES