Basler Electric DGC-2020ES - Manual (Page 207)

9469200990 Rev C 199
Fault
Code
Number
String Description
120 HI ECU SUPPLY VOLTS Power supply voltage too high (limit 1).
121 HIHI ECU SUPPLY VOLTS Power supply voltage too high (limit 2).
122 HI T ECU Temperature of electronic too high (limit 1).
134 15v POSECU DEFCT Internal electronic fault.
136 15V NEGECU DEFCT Internal electronic fault.
137 L1 5V BUFFR TEST Pressure-sensor fault, pressure-sensor wiring, or internal electronic fault.
138 SENSOR PWR DEFCT Pressure-sensor fault, pressure-sensor wiring, or internal electronic fault.
139 L1 TE BUFFR TEST Internal electronic fault.
140 TE BUF ECU DEFCT Internal electronic fault.
141 AL POWER TOO HIGH AL power too high.
142 MCR EXCEEDED 1 HR STR AL MCR exceeded 1 hour.
143 BANK1 ECU DEFECT Internal electronic fault.
144 BANK2 ECU DEFECT Internal electronic fault.
145 15V GOODECU DFCT Internal electronic fault.
147 AD TST1ECU DEFCT Internal electronic fault.
149 AD TST2ECU DEFCT Internal electronic fault.
151 AD TST3ECU DEFCT Internal electronic fault.
170 MI MODULE FAIL Module in maintenance indicator defect.
171 MI NOT ACTIVE WI not active anymore.
172 TBO EXPIRED TBO expired.
173 MODL WRITE LIMIT EEPROM write limit reached.
176 AL LIFE DATA NA No (fitting) LifeData-Backup-System is available within a delay time after ECU
Reset.
177 AL LIFE DATA INCPLT If the ADEC has to restore the LifeData from the backup-system and at least one
checksum is wrong after the upload or the upload is incomplete, then this failure
is set.
180 AL CAN1 NODE LOST Connection to a node on CAN 1 lost.
181 AL CAN2 NODE LOST Connection to a node on CAN 2 lost.
182 AL CAN WRONG PARAMS Incorrect CAN parameter values have been entered.
183 AL CAN NO PU DATA A CAN mode is selected which the communication is initialized aided of the PU
data module. However, required PU data module is not present or is not valid.
184 AL CAN PUDATA ERR During attempt to copy a received PU data module to Flash module, a program
error occurred.
185 CAN LESS MAILBXS CAN less mailboxes.
186 AL CAN1 BUS OFF CAN controller 1 is in “Bus Off” state.
187 AL CAN1 ERR PASSV CAN controller 1 has signaled a warning.
188 AL CAN2 BUS OFF CAN controller 2 is in “Bus Off” state.
189 AL CAN2 ERROR PASSV CAN controller 2 has signaled a warning.
190 AL EMU PARAM NO
SUPPORT EMU parameters are not supported.
198 AL COMB ALM YEL Combined Yellow Alarm - a yellow alarm is a warning and does generally not
result in engine shutdown.
201 SD T COOLANT Coolant temperature-sensor defect.
202 SD T FUEL Fuel temperature-sensor defect.
203 SD T CHARGE AIR Charge air temperature-sensor defect.
205 SD T CLNT INTERC Intercooler coolant temperature-sensor defect.
206 SD T EXHAUST A Exhaust gas temperature-sensor on A-side defect.
207 SD T EXHAUST B Exhaust gas temperature-sensor on B-side defect.
208 SD P CHARGE AIR Charge air pressure-sensor defect.
DGC-2020ES MTU Fault Codes