System recommendations, Installation, Activation of the dgc-2020es plugin – Basler Electric DGC-2020ES User Manual
Page 110

102
9469200990 Rev C
System Recommendations
BESTCOMSPlus software is built on the Microsoft
® .NET Framework. The setup utility that installs
BESTCOMSPlus on your PC also installs the BE1-11 plugin and the required version of .NET Framework
(if not already installed). BESTCOMSPlus operates with systems using Windows
® XP 32-bit SP3,
Windows Vista 32-bit SP1 (all editions), Windows 7 32-bit (all editions), Windows 7 64-bit (all editions),
and Windows 8. System recommendations for the .NET Framework and BESTCOMSPlus are listed in
Table 20.
Table 20. System Recommendations for BESTCOMSPlus and the .NET Framework
System Type
Component
Recommendation
32/64 bit
Processor
2.0 GHz
32/64 bit
RAM
1 GB (minimum), 2 GB (recommended)
32 bit
Hard Drive
100 MB (if .NET Framework is already installed on PC)
950 MB (if .NET Framework is not already installed on PC)
64 bit
Hard Drive
100 MB (if .NET Framework is already installed on PC)
2.1 GB (if .NET Framework is not already installed on PC)
To install and run BESTCOMSPlus, a Windows user must have Administrator rights. A Windows user with
limited rights might not be permitted to save files in certain folders.
Installation
Note
Do not connect a USB cable until setup completes successfully.
Connecting a USB cable before setup is complete may result in errors.
1.
Insert the BESTCOMSPlus CD-ROM into the PC CD-ROM drive.
2.
When the BESTCOMSPlus Setup and Documentation CD menu appears, click the Install button for
the BESTCOMSPlus application. The setup utility installs BESTCOMSPlus, the .NET Framework (if
not already installed), the USB driver, and the DGC-2020ES plugin for BESTCOMSPlus on your PC.
When BESTCOMSPlus installation is complete, a Basler Electric folder is added to the Windows
programs menu. This folder is accessed by clicking the Windows Start button and then accessing the
Basler Electric folder in the Programs menu. The Basler Electric folder contains an icon that starts
BESTCOMSPlus when clicked.
Activation of the DGC-2020ES Plugin
The DGC-2020ES plugin is a module that runs inside the BESTCOMSPlus shell. The DGC-2020ES
plugin contains specific operational and logic settings for only the DGC-2020ES. Uploading settings to the
DGC-2020ES is possible only after activating the DGC-2020ES plugin.
The DGC-2020ES plugin can be activated automatically or manually. Automatic activation is achieved by
using a USB cable to establish communication between the DGC-2020ES and BESTCOMSPlus. Manual
activation is initiated by contacting Basler Electric for an activation key and entering the key into
BESTCOMSPlus. Manual activation is useful if you want to create a settings file prior to receiving your
DGC-2020ES. Refer to Manual Activation of DGC-2020ES Plugin.
BESTCOMSPlus
®
DGC-2020ES