Axel AX3000 65 User's Manual - Manual (Page 73)

Installing under UNIX/LINUX
AX3000 - User's Manual
61
The Axel SSH client is compliant with OpenSSH 1.5.
To accept Axel SSH connections, the SSH server must first accept connections
from SSH V1 clients and support the password authentication mechanism.
These two functions are indicated in sshd_config file by:
Protocol 2,1
PasswordAuthentication yes
d) The AUX1 and AUX2 Serial Ports
The Axel terminal supports both TCP/IP and serial (RS232) connections.
To establish a serial connection, a session must be associated with the AUX1
or AUX2 protocol.
Note: two serial sessions are supported at the same time.
The selected auxiliary port is set-up through the [Configuration]-[Ports]-
[Auxiliary Port]-[AuxX] menu (see Chapter 3.5.1). The "Operating Mode"
should be set to "Serial Session". Adjust the rest of the parameters as required.
5.1.3 - Selecting the Emulation
The following table shows the recommended emulations for the various
operating systems:
Operating Systems Pre-defined Configuration
UNIX SCO 3.2v2 UNIX SCO 3.2.2
UNIX SCO 3.2v4 UNIX SCO 3.2.4
Open Server SCO SCO OPENSERVER
Xenix SCO XENIX SCO
IBM AIX 3.x ANSI RS6000
IBM AIX 4.x HFT
Unix Ware 7 UNIXWARE 7
LINUX LINUX
UNIX Interactive ANSI INTERACTIVE
SUN - Solaris 2.x ANSI SVR4
Others ANSI, VT220 or WYSE 60