Axel AX3000 65 User's Manual - Manual (Page 237)

Appendix
AX3000 - User's Manual
225
This is a screen-shot example when the resolution successes:
Connecting to as400.servers.axel.com:23 (Telnet)...
Session number 1
Resolving...
Resolved: 192.168.1.180
Connected
Explanation: the AX3000 attempts to resolve "as400.servers.axel.com". The
resolution process returns the IP address which is 192.168.1.180.
In the event of a problem, the "Resolved: a.b.c.d" message is replaced by an
error message. For example:
Connecting to as400.servers.axel.com:23 (Telnet)...
Session number 1
Resolving...
Srv: domain not found
Press to close this session
Error messages: error messages reported by the DNS server begins with Srv.
Error messages from the terminal begin with "Loc". The main messages are:
- Srv: domain not found: the name doesn't exist within this domain.
- Srv: refused query: the DNS servers refuses to respond to the request.
This could be due to a DNS server security function.
- Loc: no DNS server defined: no DNS server has been defined through
the AX3000 Set-Up.
- Loc: name syntax error: the syntax of the name to resolve is not correct
(for example two consecutive dots: as400..servers).
- Loc: timeout: no DNS server responds
- Loc: no memory: due to a temporary memory overload, the AX3000 can
not process the name resolution. Retry later.
When the resolution fails, the session must be manually closed. This is done by
pressing .
A.4.3 - Publishing the Terminal Name
The terminal name may be registered with the DNS server. This can be done by
the DHCP server or by the terminal itself.