Axel AX3000 65 User's Manual - Manual (Page 201)

Remote Set-Up
AX3000 - User's Manual
189
The possible connection errors are:
- The interactive set-up is already in use on the target terminal.
- The client telnet doesn't negotiate a TERM value "ansi".
10.2 - BATCH REMOTE SET-UP
This feature enables an AX3000 to be set up remotely, using the remote
administration command. A text file (provided as an argument to the remote
administration command) defines the value of some or all set-up parameters. It
can either be:
- created with a text editor or
- obtained by a remote administration command on an AX3000 already
set-up.
The remote administration command depends on the operating system. Refer
to the Chapter 5.5 (Unix/Linux), the Chapter 6.4 (OS/400) or the Chapter 7.3
(OS/390).
The remote administration command parameters are:
- the name or the IP address of the AX3000,
- a command: one of the 3 following keywords:
- setup_send : set-up an AX3000,
- setup_get
: get an AX3000 configuration,
- ax_reboot : reset an AX3000.
Note: to access an AX3000 with the rsh command, the IP address of the
AX3000 must already have been set
10.2.1 - AX3000 Remote Set-Up
To set-up an AX3000 remotely, use the 'setup_send' command. Example for
Unix/Linux:
# rsh axname setup_send password < conf_file