Axel AX3000 65 User's Manual User Manual
Page 251

Appendix
AX3000 - User's Manual
239
Note: when a configuration file is obtained from an AX3000:
- the value of "term_operating_mode" is commented out.
- "term_screensaver_delay" is commented out when the value of
"term_screensaver" is "no",
- "xxx_password" parameters are always commented out.
Session Parameters
In the following section of the file, for ease of reading the session number (1 to
6) has been represented by the '%' character. In a real configuration file, the
parameters for each session would, of course, be listed.
s%_predefined_setup=ansi
(rdp | ica | vnc | 5250 | 3270 |
ansi | ansi dos | unix sco 3.2.2
unix sco 3.2.4 | sco openserver
xenix sco | unix svr4 | ansi mos
ansi interactive | ansi rs 6000
ansi data general | vt220 | vt52
c332 | sm9400 | sm9412
ato300 | hft)
s%_associate_protocol=telnet
(telnet | tty)
s%_associate_host=vangogh
(character string, 64 char max.)
s%_secondary_host=
(character string, 64 char max.)
s%_associate_term=ansi
(character string, 10 char max.)
s%_associate_devname=
(character string, 20 char max.)
s%_associate_autoconn=yes
(yes | no)
s%_associate_reconn=yes
(yes | no)
s%_associate_label=view 1
(character string, 10 char max.)
s%_associate_tcpport (number)
s%_associate_realport (number)
s%_associate_to
(yes | no)
s%_associate_toval (number)
s%_associate_script=
(character string, 60 char max.)
s%_associate_username=
(character string, 10 char max.)
#s%_associate_enpassword=
(character string, 30 char max.)
#s%_associate_password=
(character string, 10 char max.)
s%_associate_progname=
(character string, 10 char max.)
s%_associate_menuname=
(character string, 10 char max.)
s%_associate_libname=
(character string, 10 char max.)