Axel AX3000 65 User's Manual User Manual
Page 218
Downloading Firmware
206
AX3000 - User's Manual
AX BOOTP V1.1a
Flash Key 3
Next, an automatic connection to the tftp host will then be made, in order to
download the firmware file.
11.4.2 - The tftp Stage
AX TFTP V1.1a
Flash Key 3
If the download can be performed, the current firmware is erased and the
following message is displayed on the AX3000 monitor:
Erasing code...
Then, the selected firmware file is downloaded (each dot represents 512 bytes):
Loading code
.........................................................................
.........................................................................
.........................................................................
.........................................................................
.....
code loaded
Finally, the AX3000 is automatically reset and the new firmware is enabled.
IMPORTANT: The AX3000 IP layer, used for the tftp protocol, does not handle
the fragmentation/defragmentation process. Therefore, if a router fragments
frames (mtu lower than 600 bytes), the AX3000 will not be able to perform the
download.