Axel AX3000 65 User's Manual - Manual (Page 159)

Installing under Windows
AX3000 - User's Manual
147
Note: the destination (ICA server or published application) may be left blank. In
this case when the ICA connection is established (Alt-Fx), the user must select
the target from a list.
b) ICA Browser Settings
For the "ICA Server" and "Published Application" target types, the ICA Browser
Settings are used to dynamically build the server or application list (when
is pressed).
Within the 'Session Profile' box, select 'ICA Browser Settings' and press
. The following box is displayed:
These parameters are:
- Exploration Protocol: two available values:
- TCP/IP + HTTP: XML-based protocol
- TCP/IP: UDP-based protocol
For more information please see the Metaframe Manual.
- TCP Port: with "HTTP + TCP/IP" mode, the default value is 80 and can
be modified. With "TCP/IP" mode the value is 1604 and can't be modified.
- IP Address or DNS Name: depending on the exploration protocol, the
ICA browsing behaviour differs:
- TCP/IP + HTTP: when this parameter is left blank, the ICA request
is sent to the DNS name 'ica'. Otherwise it is sent to the entered
DNS name or IP address.
- TCP/IP: when this parameter is left blank, the ICA request is
broadcasted. When a value is specified, the ICA request is sent to
the entered IP address or name (unicast mode). In event of failure
the ICA request is sent again in broadcast mode.