Axel AX3000 65 User's Manual User Manual
Page 227
Appendix
AX3000 - User's Manual
215
Two types of router can be used to access remote networks:
- a default router: this router knows how to reach many remote networks.,
- specific routers: in charge of one remote network.
The default router is only identified by an IP address.
The specific routers are identified by the following parameters:
- Router IP address: this router must be connected to the same network
as the AX3000.
- Destination IP Address: IP address of the host or the network to be
reached.
- Destination Type: two values:
- Host: the destination is a single host,
- Network: the destination is a whole local network (the class mask
is applied to this IP address).
Notes:
- At the AX3000 level, the routing algorithm uses a specific router to reach
the destination. If no specific router fits, the default router is used.
- The AX3000 doesn't support ICMP REDIRECT requests (dynamic
routers are not supported).