AMETEK SFA Series Ethernet Programming - Manual (Page 90)

SCPI Command Operation SG Series Programming
6-18 M550129-03 Rev K
6.7 OUTPUT SCPI COMMAND SUBSYSTEM
This section first presents a tree summary of the OUTPut commands and
then provides a tabular description.
6.7.1 OUTPUT SCPI Command Summary
OUTPut
:ISOLation
:ISOLation?
:POLarity
:POLarity?
:PROTection
:DELay
:DELay?
:FOLD <0|1|2>
:FOLD?
:SENSe
:SENSe?
:STATe
:STATe?
:TRIPped?
6.7.2 OUTPUT SCPI Command Reference
The letter “C” in the “SCPI” column means that the command syntax is
SCPI compliant; an “N” in the “SCPI” column means that the command
syntax is not part of the SCPI definition.
Command Description SCPI
OUTPut Output subsystem. C
:ISOLation
Sets the rear panel isolation relay control signal ON or OFF. Valid
arguments are 1/ON or 0/OFF.
N
:ISOLation? Returns the state of the rear panel isolation relay control signal: 1 =
ON 0 = OFF
N
:POLarity
ON> Changes the state of the polarity relay. This command requires that
the isolation relay be open beforehand. If the isolation relay is
closed when this command is attempted, the state of the polarity
relay will not change, and an error message will be generated.
C
:POLarity? Returns the state of the polarity relay:
C
:PROTection Output Protection subsystem. N
:DELay Sets the programmable time delay executed by the supply before
reporting output protection conditions after a new output voltage or
current is specified. Functional granularity of +/- 0.5 seconds
N
:DELay? Returns the time delay to be executed by the supply. N