AMETEK SFA Series Ethernet Programming - Manual (Page 83)

SG Series Programming SCPI Command Operation
M550129-03 Rev K 6-11
Command Description
*SRE
<0+NR1>
Sets the value of the Service Request Enable Register, which
determines which bits in the Status Byte will cause a service
request from the device. See section on Status Byte for valid
values.
*SRE?
Returns the integer value of the Service Request Enable Register.
See section on Status Byte for valid values. Values range from 0-
63 or 128-191.
Response: <0+NR1>
*STB?
Returns the integer value of the Status Byte with bit 6 representing
the Master Summary Status (MSS) instead of RQS. The MSS bit
acts as a summary bit for the Status Byte and indicates whether the
device has at least one reason to request service based on the
MAV and the ESR bits. The Status Byte is cleared. See section on
Status Byte for valid values. Values range from 0-255.
Response: <0+NR1>
*TST?
Sets the device to execute an internal self-test and return the
integer value of the results. Value of “0” indicates no errors.
Response: <0+NR1>
*WAI
Sets the device to wait until all previous commands and queries are
complete before executing commands following the *WAI
command.