AMETEK SFA Series Ethernet Programming - Manual (Page 49)

SG Series Programming Ethernet Configuration and Remote Programming
M550129-03 Rev K 5-9
5.2.6 Remote/Local Selection
Set the rear panel Remote/Local switch to select remote or local operation.
Remote ON switch (rocker) is top depressed.
Table 5-1. Remote/Local Switch
Switch Position
Description
ON Remote operation selected.*
OFF
Local operation selected, and front panel control is enabled.
NOTE: Unit will switch to remote operation upon issuing the first
Ethernet or RS232 non-query command.
* In the ON position, the power hardware and Ethernet card initialize to the
remote state at power-on.
When in remote operation, the front panel control remains disabled
regardless of the state of the REN (Remote ENable) line, or the GTL (Go To
Local) command.
To revert to front panel control, use the special command
SYST:LOCAL .
Powering up in remote mode will result in the operating conditions described in Table
5-2.