Features and functions, Features, Programmable functions – AMETEK SFA Series Ethernet Programming User Manual
Page 34

Ethernet Features, Functions and Specifications
SG Series Programming
4-2
M550129-03 Rev K
I
NTERNET OR
LAN
C
ONNECTION
To operate your Sorensen Ethernet product connected to the Internet or a
LAN you will need:
•
Pentium-based laptop or desktop computer running Microsoft Windows
XP (or better)
•
Ethernet based Network Interface Card (NIC) or built-in port capable of
10/100 MBit operation
•
Appropriate Ethernet modem for Internet connection, or
•
Switch or hub (Linksys brand strongly recommended) for LAN
connection
•
Standard CAT 5 Ethernet interconnect cable
•
Microsoft Internet Explorer version 6.0 or later
•
Sun Microsystems Java Runtime Environment
4.2
FEATURES AND FUNCTIONS
4.2.1
Features
•
Ethernet/LAN connectivity, 10/100base-T compatible
•
Fully
™ (LAN eXtensions for Instrumentation) class C compliant
•
Built-in Web Server for direct control using Internet Explorer 6.0 or
higher
•
16-bit programming and 16-bit readback of voltage and current
•
Programmable overvoltage protection with reset
•
SCPI compliant command set
•
User-programmable signals including Local/Remote Sense relay drive,
External Polarity relay drive, and Disconnect (Isolate) Relay Drive
•
User selectable Constant-Voltage/Constant-Current or Foldback mode,
with reset
•
Voltage Ramp and Current Ramp functions
•
Field-upgradeable firmware via RS232
•
Full calibration through software control
•
Rear panel Ethernet/IEEE-802.3 and RS232 control interface
•
Rear panel External User Control Signal Interface
(Includes optically isolated external hardware trigger input)
•
Rear panel configuration switch
4.2.2
Programmable Functions
•
Output voltage and current