AMETEK SFA Series Ethernet Programming - Manual (Page 65)

SG Series Programming Ethernet Configuration and Remote Programming
M550129-03 Rev K 5-25
Last Calibration Date: displays the date that the power supply
(instrument) was last calibrated; configurable with SCPI commands,
normally at the time of calibration.
Next Calibration Date: displays the date that the power supply should be
calibrated next; also configurable with SCPI commands, normally
calculated at time of calibration.
Ping Echo: except for Read Only users, allows turning echo ability On or
Off, depending on whether or not you want the supply to respond to a
Ping command from another device on the network. The default setting
for Ping Echo is response enabled. Click the OFF radio button if you do
not want the supply to respond to a ping.
Ping Remote IP Address: allows you to input an IP address of another
device in the system
Ping: click this button to ping the device at the address that you entered
in the Ping Remote IP Address field.
Response: displays the result of your ping. For Example, if the Ping
Address were 69.36.230.190, the Response window would display:
Pinging :69.36.230.190 Response Took 0 ticks
Or
Ping Failed (if the host specified is not in the network)
CLEAR RESPONSES: click this button to clear the Response window of
past ping responses.