AMETEK SFA Series Ethernet Programming - Manual (Page 107)

SG Series Programming SCPI Command Operation
M550129-03 Rev K 6-35
6.13.3 SGI PROGRAM SCPI Command Subsystem
The PROGRAM subsystem, only available in SGI, provides a means to
program sequences. Through sequences power supply output settings
and duration for each of those individual settings, called sequence steps,
can be programmed. A sequence step includes a voltage value with a
current value with an over-voltage-protection value with a duration value.
A single sequence is a program of up to 20 steps (21 steps if the
RETURN or STOP or GOTO is counted), where one step consists of a
setting for the power supply output. There may be up to 50 different
named sequences (programs) with up to 20 steps in each. (The default
name for a program is TEST[n], where [n] is a number 01 thru 50, but
may be reprogrammed with a unique name up to 15 characters.)
NOTE: Do NOT use non-sequence-related commands while performing
sequences. Also do NOT use sequence commands as stand-alone
commands outside a sequence.
PROGRAM SCPI C OMMAND S UMMARY
PROGram
:INITializing?
:CATalog?
:[SELected]
:ARM
:ARM?
:DEFine ,VIMODE,,,,
:DEFine
,RAMPTOV,,,,,
:DEFine
,RAMPTOC,,,,,
: DEFine ,POWERSETTINGS,,,,,
:DEFine ,REPEAT
:DEFine ,SUBCALL, “SEQNAME”
:DEFine ,RETURN
:DEFine ,LOOP,
:DEFine ,NEXT
:DEFine ,STOP
:DEFine ,GOTO, “SEQNAME”
:DEFine ,PAUSE
:DEFine ,NOP
:DEFine?
:DELete
:SELected
:ALL
:EXECute ,,,…,
:EXECute VIMODE
:EXECute RAMPTOV
:EXECute RAMPTOC
:EXECute POWERSETTINGS
:MALLocate DEFAULT
:NAME “name”