beautypg.com

Status – AMETEK SFA Series Ethernet Programming User Manual

Page 64

background image

Ethernet Configuration and Remote Programming

SG Series Programming

5-24

M550129-03 Rev K

5.5.4

STATUS

The Status page displays updated information for the following parameters:

Figure 5-16. Status Page

Output: displays the power output status, ON or OFF

Trigger: set up by SCPI commands, displays whether the Trigger state is
OFF, ARMED, or TRIGGERED.

OVP: displays Read Only status of over voltage protection, either OK
(normal) or TRIPPED.

FAULT: displays Read Only status of over temperature condition, either
OK (normal) or TRIPPED.

Command Error: displays command and syntax errors that are queued
in the supply.

READ NEXT ERROR: each click brings the next error into the Command
Error display, until no other errors are in the queue.

CLEAR MESSAGES: click this button to clear the Command Error
message window of past messages.