AMETEK SFA Series Ethernet Programming - Manual (Page 19)

M550129-03 Rev K 1-1
SECTION 1
OVERVIEW
1.1 INTRODUCTION
This manual provides instructions for full remote programming control and
monitoring from a computer, for your SG series high power DC power supply.
For easy navigation to the applicable instructions, this manual separates
GPIB and RS232 setup instructions from Ethernet setup instructions. The
instructions then converge where they are common to all three interface
options. See Sections 1.2 and 1.3 for orientation. Use this programming
manual in conjunction with your SGA or SGI Operation manual.
1.2 IEEE 488.2 GPIB AND RS232 OPTIONS
If you are using the IEEE 488.2 GPIB or RS232 interface, go to:
•
Section 2 for features, functions and specifications,
•
Section 3 for configuration and remote programming setup
•
Section 6 for SCPI commands and definitions
•
Section 7 for calibration procedures
•
Section 8 for SCPI Status Implementation
1.3 ETHERNET OPTION
If you are using an Ethernet interface, go to:
•
Section 4 for features, functions, and specifications
•
Section 5 for configuration and for programming setup of your SG power
supply via the Ethernet
•
Section 6 for SCPI commands and definitions
•
Section 7 for calibration procedures
•
Section 8 for SCPI Status Implementation