AMETEK SFA Series Ethernet Programming - Manual (Page 76)

SCPI Command Operation SG Series Programming
6-4 M550129-03 Rev K
requests based on the Protection Event Status Register, program both the
Protection Event Status Enable Register and the Service Request Enable
Register (*SRE). For further information, refer to the table below, and to
SCPI Status Implementation page 8-1.
Table 6-3. Protection Condition and Event Status Registers
Bit Hex Value Description
0 0x01 Constant voltage operation
1 0x02 Constant current operation
2 0x04 Not used
3 0x08 Overvoltage protection tripped
4 0x10 Overtemperature protection tripped
5 0x20 Supply external shutdown active
6 0x40 Foldback mode operation
7 0x80 Remote programming error