AMETEK SFA Series Ethernet Programming - Manual (Page 85)

SG Series Programming SCPI Command Operation
M550129-03 Rev K 6-13
[:AMPLitude]
[:AMPLitude?]
:PROTection
:PROTection?
[:LEVel]
[:LEVel?]
:TRIPped?
:STATe?
:CLEar
:RAMP
:RAMP?
:ABORt
:ALL?
:HTRIGgered
:HTRIGgered?
:TRIGgered
:TRIGgered?
:TRIGgered
:TRIGgered?
:CLEar
:AMPLitude
:AMPLitude?
6.5.2 SOURCE SCPI Command Reference
The letter “C” in the “SCPI” column means that the command syntax is
SCPI compliant; an “N” in the “SCPI” column means that the command
syntax is not part of the SCPI definition.
Command Description SCPI
SOURce Source subsystem. C
:CURRent Sets the output current in amps (default) or in milliamps. C
:CURRent? Returns the output current in amps or in milliamps C
[:LEVel] Sets the output current in amps (default) or in milliamps. C
[:LEVel?] Returns the output current in amps or in milliamps. C
[:IMMediate] Sets the output current in amps (default) or in milliamps. C
[:IMMediate?] Returns the output current in amps or in milliamps C
[:AMPLitude]
Sets the output current in amps (default) or in milliamps. C
[:AMPLitude?] Returns the output current in amps or in milliamps C
:LIMit
Sets an upper soft limit on the programmed output current
for the supply. The soft limit prevents the supply from being
inadvertently programmed above the soft limit, thus
providing a method for protecting the load against
damaging currents.
C
:LIMit?
Returns the upper soft limit on the programmed output
current for the supply.
C
[:AMPLitude]
Sets an upper soft limit on the programmed output current for
the supply.
C
[:AMPLitude?]
Returns the upper soft limit on the programmed output
current for the supply.
C