AMETEK SFA Series Ethernet Programming - Manual (Page 54)

Ethernet Configuration and Remote Programming SG Series Programming
5-14 M550129-03 Rev K
5.5 ETHERNET WEB PAGES, OVERVIEW
The layout of each of the Web pages includes the banner with the
heading, “Sorensen SGI (or SGA) Power Supply Interface” along with the
device name below and a LOGIN button to the right. Below the SGI
banner are eight tabs (six tabs in the SGA banner), each linked to its
corresponding page. On each page is a title line (title matches tab name).
In the title line is an area that frequently displays informational messages
(when warranted) as you use the Web interface, such as a confirmation
message or an error message.
Figure 5-9. SGI Banner and Tabs
Figure 5-10. SGA Banner and Tabs
Note: There are few differences between the SGA interface and the SGI
interface: their titles and device names in the banner, their specifics in the
Home page, and SGI has two pages that are not included in the SGA:
Power and Presets. Unless SGA and SGI interfaces are both shown, most
illustrations use only the SGI interface.
When navigating to the Ethernet Web pages by clicking their tabs, you will
find that only the HOME page (default) may be accessed without logging
in. You must log in (click LOGIN) before tabbing to the other pages, which
allow access by permission only: FULL (Administrator), RW (Read\Write),
or R (Read).
•
FULL permissions users have access to all pages and all channels and
may configure the interface, set and change security settings, allocate
channels, control the output of the power supply, send commands, etc.
•
RW permissions users may access all pages except SECURITY, and
may read and control the output of the power supply for only the
channels allocated to them. They are not authorized to make changes
on the IP CONFIGURATION page.
•
R permission users may read information related only to the channels
allocated them, and cannot make any changes or control the output.