AMETEK SFA Series Ethernet Programming - Manual (Page 87)

SG Series Programming SCPI Command Operation
M550129-03 Rev K 6-15
Command Description SCPI
[:IMMediate]
Sets the output voltage of the supply in volts (default) or in
millivolts.
C
[:IMMediate?]
Returns the output voltage of the supply in volts or in
millivolts.
C
[:AMPLitude]
Sets the output voltage of the supply in amps (default) or in
milliamps.
C
[:AMPLitude?]
Returns the output voltage of the supply in amps or in
milliamps.
C
:LIMit
Sets the upper soft limit on the programmed output voltage.
The soft limit prevents the supply from being inadvertently
programmed above the soft limit, thus providing a method
for protecting the load against damaging voltages.
C
:LIMit?
Returns the upper soft limit set on the programmed output
voltage.
C
[:AMPLitude]
Sets the upper soft limit on the programmed output voltage. C
[:AMPLitude?]
Returns the upper soft limit on the programmed output
voltage.
C
:PROTection
Sets the overvoltage protection trip point in volts (default) or
in millivolts.
C
:PROTection?
Returns the set overvoltage protection trip point in volts
(default) or in millivolts.
C
[:LEVel]
Sets the overvoltage protection trip point in volts (default) or
in millivolts.
C
[:LEVel?]
Returns the set overvoltage protection trip point in volts or in
millivolts.
C
:TRIPped?
Returns 1 (TRIPPED) or 0 (UNTRIPPED) state of the
overvoltage protection circuit.
C
:STATe?
Returns the state 1 (ON) or 0 (OFF) If the overvoltage
protection is enabled.
C
:CLEar Clears the overvoltage protection circuit. C
:RAMP
Sets the output voltage to ramp from the present value to the
specified value (first argument) in the specified time (second
argument). See Ramp Function description Section 6.5.3.
N
:RAMP?
Returns 1 if the ramp is in progress, and 0 if the ramp is
completed.
N
:ABORt Aborts ramping and clears trigger mode. N
:ALL? Returns the ramping status of all channels. N
:HTRIGgered
Sets the value of the output voltage ramp to be implemented
when the hardware trigger is received.
N
:HTRIGgered?
Returns the value of the output voltage ramp to be
implemented when the hardware trigger is received.
N