AMETEK MX15 Series - Manual (Page 72)

User Manual – Rev M California Instruments
MX15 72
Once the power on sequence is completed, the power source will always revert to the
PROGRAM screen shown here. The power source is now ready to be used.
4.2.2 Top Level Menus
The following top-level menu choices can be accessed using the Menu key:
ENTRY DESCRIPTION
PROGRAM The PROGRAM menu allows primary output parameters such as
voltage, frequency, current limit, waveform shape and voltage
range to be changed.
CONTROL The CONTROL menu allows secondary setting parameters such
as sense mode, phase mode and ALC mode to be changed.
MEASUREMENTS The MEASUREMENT screen is not a menu in that no user entries
are required. It displays read-back data.
TRANSIENTS The TRANSIENTS menu allows output transients to be
programmed.
REGISTERS The SETUP REGISTERS menu allows complete instrument
settings and transient list programs to be saved to nonvolatile
memory.
CONFIGURATION The CONFIGURATION menu allows changes to be made to
configuration settings such as the IEEE-488 address, RS232C
internal baud rate, and power on state.
OUTPUT CAL The OUTPUT CAL menu provides access to the LCD viewing
angle and Calibration password entry. If the correct calibration
password is entered, additional calibration screens can be
accessed.
MEAS CAL The MEAS CAL menu allows for calibration of the AC source
measurement system.
APPLICATIONS The APPLICATIONS menu provides access to the optional
firmware application programs that may be installed in the power
source controller.
OPTIONS The OPTIONS menu provides access to optional functions that
may be present on the power source.