AMETEK MX15 Series - Manual (Page 136)

User Manual – Rev M California Instruments
MX15 136
Power up the AC source using its on/off switch while holding the ENTER key at the same
time. A sequence of messages will appear on the LCD once the power comes on:
This will put the source controller into the Flash down load mode. Wait until the screen shown
below appears. This screen shows the RS232 setup parameters that are used in the boot loader
mode.
Now launch the Flash Lo ader utility program “FlashLoaderComm.exe”.
Select the COM port to be used (default is COM1). Leave “Baud rate” and “Cmd Delay” set to
their default values of 38400 baud and 0 msec.
Click on the “Init Port” button. If the selected port can be initialized, the “Flash Update” button will
be enabled. If not, check the selected COM port and make sure it is the one connected to the
MX15.
Press the “Flash Update” button. This will display the file download screen shown below.