AMETEK MX15 Series - Manual (Page 50)

User Manual – Rev M California Instruments
MX15 50
P8 / P9 Description
21 COM: Common. Signal return.
22 /REM OFF: Remote Off Control not
23 COM: Common. Signal return
24 FLK/BYP: Flicker / Bypass OMNI control
25 /OVL: Overload not
26 CLA: Current Limit A. Programmed current limit reference for phase A
27 CLC: Current Limit C. Programmed current limit reference for phase C (Not
Used)
28 CSB: Current Sum Phase B. (Not Used)
29 N/C
30 FLT B: Amplifier Fault Phase B (Not Used)
31 N/C
32 DC: DC mode control
33 INP OFF: Input power control
34 A ERR HI: Error Signal Phase A, high
35 N/C
36 B ERR LO: Error Signal Phase B, low (Not Used)
37 C ERR HI: Error Signal Phase C, high (Not Used)
Table 3-3: System Interface Connectors
3.7.2 Analog Input Connector
Input screw-terminal strip. Functions are called out on rear panel decal. Table shows connections
from left to right when standing at the rear of the MX15 cabinet.
Pin Description
1 RPV HI. INPUT: Analog input for External Modulation
2 RPV Lo. INPUT: return.
3 EXT SYNC HI INPUT: Analog input for external sync mode.
4 EXT SYNC Lo INPUT: return.
5 RI: INPUT: Remote Inhibit. (See paragraph 3.12.)
6 RI: INPUT: return.
Table 3-4: Analog Interface Connector