AMETEK MX15 Series - Manual (Page 144)

User Manual – Rev M California Instruments
MX15 144
Figure 9-2: DO160 Main Menus
Prior to executing a test, selection of the desired test standard and group is required. Use the
shuttle to select the standard and the group if applicable.
9.3.1.5 Normal State tests
Scroll to the NORMAL STATE entry using the up and down cursor keys. Press the ENTER key to
select the NORMAL STATE screens. The screen will appear as shown in Figure 9-3.
Figure 9-3: Normal state screens
The DO160 NORMAL screens have the following tests:
1 VOLT FREQ MIN
2 VOLT FREQ MAX
3 VOLT UNBALANCE
4 WAVEFORM DISTORTION
5 VOLT MODULATION
6 FREQ MODULATION
7 POWER INTERRUPT
8 VOLTAGE SURGE
9 FREQ TRANSIENT (group 1/A(CF))
FREQ VARIATION (group 2 & 3/A(NF) & A(WF))
The above tests can be selected by scrolling to the highlighted selection using the up and down
key and the ENTER key to start the selected test. For some of these tests, numeric data entry
may be required to define the test number or the modulation rate.
VOLT FREQ MIN
Standard/Group RTCA A(CF) A(NF) A(WF)
Voltage 1 100 100 100 100