AMETEK MX15 Series - Manual (Page 17)

User Manual – Rev M California Instruments
MX15 17
2.1.4 DC Measurements
Parameter Range Accuracy (

) Resolution
Voltage 0 - 400 Volts 0.5 Volts 0.1 Volt
Current 0 - 400 Amps 0.5 Amps 0.01 Amp
Power 0 - 10 kW 30 W 10 W
Note: Accuracy specifications are valid above 100 counts. For current and power measurements,
specifications apply from 2% to 100% of measurement range.
2.1.5 Harmonic Measurements (Pi controller)
Parameter Range Accuracy (

) Resolution
Frequency fundamental 16.00 - 820 Hz 0.03% + 0.03 Hz 0.01 Hz
Frequency harmonics 32.00 Hz – 16 KHz 0.03% + 0.03 Hz 0.01 Hz
Phase 0.0 - 360.0° 2° typ. 0.5°
Voltage Fundamental 0.75V 0.01V
Harmonic 2 - 50 0.75V + 0.3% + 0.3%/kHz 0.01V
Current Fundamental 0.5A 0.1A
Harmonic 2 - 50 0.15A + 0.3% + 0.3%/kHz 0.1A
Note: Accuracy specifications are valid above 100 counts. For current and power measurements,
specifications apply from 2% to 100% of measurement range.
2.1.6 System Specification
Parameter Specification
External Modulation: 0 to 10%
Synchronization
Input: Isolated TTL input for external frequency control. Requires 5V at 5 mA for
logic high.
Trigger Input: External trigger source input. Requires TTL level input signal. Triggers on
negative edge. Response time 80 - 100

s.
Trigger Output: Programmable through transient list system. 400

s pulse for voltage or
frequency change. Isolated TTL output. Output reverts to Function strobe
when not used as Trig Out. This function is mutually exclusive with the
Function Strobe output.
Function Strobe: Active for any voltage or frequency program change. 400

s pulse for voltage
or frequency change. Isolated TTL output. This function is mutually exclusive
with the Trigger Output. Same output is used for Trigger Output if Trigger
Output is programmed as part of list system.
Output Status: Monitors status of output relay. Isolated TTL output. High if output relay is
closed, low if output relay is open.
Non volatile memory
storage: 16 complete instrument setups and transient lists, 100 events per list.
Waveforms Sine (Models with Standard controller)
Sine, square, clipped, user defined (Models with Pi controller)
Transients Voltage: drop, step, sag, surge, sweep