AMETEK MX15 Series User Manual
Page 25
User Manual
– Rev M
California Instruments
MX15
25
2.6.2
-XV Option Specifications
Consult factory for -XV option specifications.
2.6.3
-HF Option Specifications
The -HF option extends the maximum available output frequency from 819 Hz to 900 Hz. Some
restrictions are in effect at this increased output frequency level.
All other specifications of the MX15 system remain unchanged if this option is installed except as
noted in the table below.
-HF Option:
Frequency
Range:
-HF option:
16 Hz - 900 Hz
Resolution:
0.01 Hz
< from 16.00 to 81.92 Hz
0.1 Hz
> from 82.0 to 819.2 Hz
1 Hz
> from 820 to 900 Hz
Accuracy:
± 0.01 %
Phase
Accuracy:
16 - 100 Hz:
< 1.5°
100 - 500 Hz:
< 2°
500
– 819 Hz:
< 4°
819
– 900 Hz:
< 5°
Voltage
High Voltage Range
Maximum voltage at 900 Hz is 290 Vrms
Maximum frequency at 300 Vrms is 875 Hz
See Figure 2-7
Low Voltage Range
Maximum voltage at 900 Hz is 145 Vrms
Maximum frequency at 150 Vrms is 875 Hz
See Figure 2-8.
-HV Voltage Range
Maximum voltage at 900 Hz is 386 Vrms
Maximum frequency at 400 Vrms is 875 Hz .
Note: If the voltage or frequency settings shown here are exceeded for
any length of time (> 1 sec), the MX may shut down generating an over
temperature fault to protect itself.