Altera High-Speed Development Kit, Stratix GX Edition User Manual
Page 76
5–32
Quartus II Version 3.0
Altera Corporation
Nios-Based Tests
High-Speed Development Kit, Stratix GX Edition User Guide
................................................................................
................................................................................
................................................................................
................................................................................
...
nios-run: Terminal mode (Control-C exits)
-----------------------------------------
Reinitializing...
[lan91c111] nr_lan91c111_reset: chip id = SMC91C11xFD
[lan91c111] r_lan91c111_detect_phy: found lan83C183 (lan91C111 internal)
[lan91c111] r_lan91c111_init_phy: phy negotiation timed out
[lan91c111] r_lan91c111_init_phy: 10bt
[lan91c111] r_lan91c111_init_phy: half duplex
[dhcp] 1 timing out
[dhcp] 2 timing out
[dhcp] 3 timing out
[dhcp] 4 timing out
[dhcp] 5 timing out
[dhcp] 6 timing out
[dhcp] 7 timing out
[dhcp] 8 timing out
[dhcp] 9 timing out
[dhcp] 10 timing out
[dhcp] 11 timing out
[dhcp] 12 timing out
11. Press reset (Stratix_PB_0) to stop the test.
12. Press Cntrl + C in the shell to exit the test program.
13. If this test passes, write the word “PASS” in the column under
Stratix in the row Stratix Nios PROTO1 I/O in the worksheet.
Compact Flash Interface (Stratix Nios Compact Flash)
For this test, perform the following steps.
1.
Verify that the serial cable is still attached to the Stratix RS-232
connector (top connector).
2.
Make sure that the compact flash card is inserted. See Figure 5–24.