Altera High-Speed Development Kit, Stratix GX Edition User Manual
Altera Measuring instruments
Table of contents
Document Outline
- About this User Guide
- 1. About this Kit
- 2. Before You Begin
- 3. Board Setup
- 4. Run the Preloaded Diagnostic Tests
- 5. Perform the Production Diagnostic Tests
- Required Hardware & Software
- Set Up the Board
- Perform the Standard Tests
- User I/O
- Stratix GX-to-Stratix Bridge
- Source Synchronous HM-Zd Interface (Stratix GX HM-Zd SPI 4.2)
- Source Synchronous DPA SMA interface (Stratix GX SMA DPA)
- Gigabit Transceivers with SMA Interface (Stratix GX SMA XCVR)
- Gigabit Transceivers with HM-Zd Interface (Stratix GX HM-Zd XCVR)
- Gigabit Transceivers with SFP Interface (Stratix GX SFP XCVR)
- Gigabit Transceivers with XPAK Interface (Stratix GX XPAK XCVR)
- Gigabit Transceivers with HSSDC2 Interface (Stratix GX HSSDC2 XCVR) (GX40 Device Only)
- Nios-Based Tests
- DDR Interface (Stratix GX Nios DDR)
- PMC Card Interface (Stratix Nios PMC)
- Ethernet, On-Board Flash & EPC16 Flash Interface (Stratix Nios Ethernet) (Stratix Nios On-Board Flash) (Stratix Nios EPC16 Flash)
- 10/100 Ethernet Network-Interface Card I/O Interface (Stratix Nios PROTO1 IO)
- Compact Flash Interface (Stratix Nios Compact Flash)
- Finishing Test & Breakdown
- 6. Troubleshooting
- 7. Diagnostic Test Details
- 8. Stratix GX SPI-4.2 Demonstration with 10-Port Gigabit Ethernet MAC
- 9. 10-Gigabit Ethernet MAC Demonstration