Altera High-Speed Development Kit, Stratix GX Edition - Manual (Page 131)

Altera Corporation Quartus II Version 3.0 8–3
Stratix GX SPI-4.2 Demonstration with 10-Port Gigabit Ethernet MAC
Figure 8–1. Demonstration Setup Example
The following instructions describe how to set up the Stratix GX
development board and Intel BenNevis IXF 1110 for use with the
demonstration.
1. Turn off power to the Stratix GX development board.
a. Ensure that SW3 is in the off position (which is down, when
viewing the board in anupright position).
b. Ensure that SW2 GX_BYPASS is in the no position.
c. Ensure that SW1 STRATIX_BYPASS is in the yes position.
2. Connect power to the Stratix GX development board.
a. Connect the power supply cable to connector J31.
b. Connect the ByteBlaster II cable to connector J87.
3. Connect power to Intel BenNevis board. Boards may vary, so refer
to the Intel installation guide for instructions.
Optics
Optics
Optics
Optics
Intel
(IXF1110)
10xGE MAC
Intel Board (IXD1110)
HM-Zd
Connector
HM-Zd
Connector
Altera Board
SPI-4.2
800 Mbps
Stratix GX Device
Hard
DPA
PL4 Core
(Rx, 10-Port
MPHY)
PL4 Core
(Rx, 10-Port MPHY)
Gigabit Ethernet -
Traffic Stimulus & Capture
Agilent Logic Analyzer