Altera High-Speed Development Kit, Stratix GX Edition - Manual (Page 73)

Altera Corporation Quartus II Version 3.0 5–29
Perform the Production Diagnostic Tests Nios-Based Tests
Checking Written Data:
Test Done: Goodbye...
#77153008
lan16_all_flash4_pcb_revb
+
16. Press reset (Stratix_PB_0) to stop the test.
17. Press Ctrl + C in the shell to exit the test program.
18. If this test passes, write the word “PASS” in the column under
Stratix in the row Stratix Nios On-Board Flash and Nios EPC16
Flash in the worksheet.
10/100 Ethernet Network-Interface Card I/O Interface (Stratix
Nios PROTO1 IO)
For this test, perform the following steps.
1. Change the programming file for the Stratix device to the
st_1s40.sof
file. Wait until the checksum field is updated.
2. Turn on the Program/Configure option for the Stratix device.
3. Click Start. When configuration is complete, the S_CONF_DONE
LED illuminates.
4. Choose Programs > Altera > SOPC Builder <version> > SOPC
Builder SDK Shell
(Windows Start menu).
5. Change to the Nios SOFs directory by typing the following
command:
cd /Stratix_GX_kit/Test_designs/Nios_test_designs/
Nios_sofs r
6. Type nr -t r to open a terminal window that connects to COM 1.
7. Press the Enter key twice in the terminal window. You should be at
a Nios prompt.
8. Confirm that you are connected to the Nios processor running on
the board by pressing the Enter key a few times in the terminal
window to display the processor’s memory contents.