Cisco 15327 - Manual (Page 476)

A-2
Ethernet Card Software Feature and Configuration Guide, R7.2
Appendix A Command Reference
[no] bridge bridge-group-number protocol {drpri-rstp | ieee | rstp}
[no] bridge bridge-group-number protocol {drpri-rstp | ieee |
rstp}
To define the protocol employed by a bridge group, use the bridge protocol global configuration
command. If no protocol will be employed by the bridge group, this command is not needed. To remove
a protocol from the bridge group, use the no form of this command with the appropriate keywords and
arguments.
Syntax Description
Defaults N/A
Command Modes Global configuration
Usage Guidelines The Rapid Spanning Tree Protocol (RSTP) or Spanning Tree Protocol (STP) can be implemented.
Examples The following example assigns the protocol to the bridge group with the bridge group number of 100.
Router(config)# bridge 100 protocol rstp
Related Commands bridge-group
Parameter Description
drpri-rstp The protocol that enables the Dual Resilient Packet Ring Interconnect
(DRPRI) feature of the ML-Series cards.
Note DRPRI is not supported in Release 7.2.
ieee IEEE 802.1D Spanning Tree Protocol.
rstp IEEE 802.1W Rapid Spanning Tree Protocol.
bridge-group-number The identifying number of the bridge group being assigned a protocol.