Keri Systems Doors NetXtreme - Manual (Page 53)

Figure 48: Reset Controllers
Keri Systems, Inc. Doors NetXtreme TM Reference Manual
01945-100 Rev. 4.0 Page 51
16.0 Reset Controllers Remotely Through DoorsNXT
A controller reset may be performed through the DoorsNXT software. Go to Setup > Setup Options and
Preferences.
1. Enter the Operator Name and Password as shown in “Log On to DoorsNXT” on page 6. When the
correct Operator Name and Password is entered, the side window appears automatically.
2. Use the drop-down menu to select the controller(s) to be reset remotely.
NOTE: If a controller has not been assigned an IP address it will not show in the drop-down menu.
Also, if there is only one controller on the network you may only select the “all” option.
3. A basic reset will perform a power cycle on the controller. To perform a basic reset, click on the
“Basic Reset” button.
4. A memory reset will erase all data memory from the controller (leaving IP informtion). To perform
a memory reset, click on the “Memory Reset” button.
5. A factory default restores the controller to how it was received from the factory (with all data and
IP information erased). To reset the controller to the factory default, click on the “Factory Defaults”
button.