Keri Systems Doors NetXtreme - Manual (Page 35)

Figure 30: Assign Outputs Property Set
Keri Systems, Inc. Doors NetXtreme TM Reference Manual
01945-100 Rev. 4.0 Page 33
9.2.3 Assign Outputs Property Set
Click on Setup > System > Configure Controllers > Outputs (tab).
1. Click on the to reveal all doors on the controller.
2. Verify the Outputs tab has been selected to insure that all outputs in the system are visible.
3. To change the property set of an output, use the drop-down menu and select from the output
property sets designed earlier. Outputs that are in use by the system and unable to be changed are
shown in grey with “In Use By Door” shown.
4. Click on the “Apply Changes” button to save configuration, or click on the “Undo Changes” to
clear all changes made.