Keri Systems Doors NetXtreme - Manual (Page 40)

Doors NetXtreme TM Reference Manual Keri Systems, Inc.
Page 38 01945-100 Rev. 4.0
11.0 Credential and User Enrollment
Credentials and Users are enrolled separately. Once they are enrolled, credentials may be assigned to
individual users. More than one credential may be assigned to an individual user.
11.1 Enroll Credentials
Figure 35: Enroll Credentials - Block Enrollment
11.1.1 Enroll Credentials - Block Enrollment
Click on Setup > Users > Credentials (tab).
1. Click on the “Create Credentials” button.
2. Click on the “Start New Set” button.
3. From the drop-down menu select the credential format.
4. If Dual Verification has been enabled, the “Type” column will appear. Use the drop-down menu to
select whether the credential is to be a primary or secondary credential.
5. Enter the digits of the first sequentially numbered credential to be enrolled.
6. Enter the digits of the last sequentially numbered credential to be enrolled.
NOTE: Block enrollment may only be performed using sequentially numbered credentials. If there is
any gap in the numbering, then the credentials should be broken up into groups without any gap in the
numbering and enrolled separately.
7. If there is a Facility Code required, enter that number in the field.
8. Click on the “Create Block” button.
9. The credentials are enrolled and visible for verification.
10. Click on the “Apply Changes” button.