Keri Systems Doors NetXtreme - Manual (Page 47)

Figure 42: Assign Property Set To In/Out Reader
Keri Systems, Inc. Doors NetXtreme TM Reference Manual
01945-100 Rev. 4.0 Page 45
12.3 Assign Property Set To In/Out Reader
Click on Setup > System.
1. Click on the “Configure Controllers” tab.
2. Click on the “+” to expand the controller information.
3. Select the “Doors/Gates” tab.
4. Select the bus that has the In/Out Reader(s) attached.
NOTE: It is very important to do the following steps in the order specified. Failure to do so may cause
other columns that need to be set to not appear.
5. In the Properties column, select the In/Out Reader property set created previously.
6. In the Reader column, use the drop-down menu to select “unassigned” on a different bus (this will
be used as the “out” reader).
7. The Reader B column appears (if this column is not visible then In/Out Reader has not been
enabled). Use the drop-down menu to select the reader that was unassigned in the Reader column.
This will be the “out” reader.
8. Go through the remaining columns to assign the options as desired.
9. Click on the “Apply Changes” button.