Keri Systems Doors NetXtreme - Manual (Page 31)

Figure 24: Input Property Sets
Figure 25: Output Property Sets
Keri Systems, Inc. Doors NetXtreme TM Reference Manual
01945-100 Rev. 4.0 Page 29
9.1.3 Configure Input Property Sets
Click on Setup > System > Properties (tab) > Inputs.
1. Click “Add New” button or “Duplicate” button.
2. Rename the Property set name.
3. Set Input Mode: Not Used, Normally Open, Normally Closed.
4. Set Supervision: None (2 State), 3 State, 4 State.
5. Set Monitor Timezone: Always, Never, created timezones.
6. Apply Changes or Undo Changes.
9.1.4 Configure Output Property Sets
Click on Setup > System > Properties (tab) > Outputs.
1. Click on the “Add New” button or “Duplicate” button.
2. Rename the Property set name.
3. Set Normal Output State: Not Used, Energized, Deenergized.
4. Set Active Time: Supervision: anywhere between Always and 86,400 seconds (1,440 minutes or 24
hours).
5. Set Output Use: General or Elevator.
6. Apply Changes or Undo Changes.