Lj 5 tl p jogging operation, O o p, 5 t l p – Toshiba Tosvert VF-A5 User Manual

Page 76: Jogging operation, Ldbl.i i

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

O r

^ p- (Frequency Setting Parameters)

O O P

5 t l P

Jogging operation

Related parameters

Jog run frequency

J D O

J 5 b P Jog stop control

A jog run can be started and stopped with the F, R terminal signals by setting the jog run frequency

J D O

. (Refer to the section on

O r . 5 1

I h * I

for allocating the input terminals.)

* Short circuit JOG-CC before starting a jog run.

Jog forward run

Jog reverse run

Runs at the operating frequency set from the panel or terminal block when JOG-CC is opened.

* Jogging will not occur if JOG-CC is shorted while running.

* When using JOG run and preset speed run modes simultaneously, the preset speed run mode will have

priority. (For example, if the preset speed run mode is set for reverse run, the preset speed is selected by

SS1-SS4, and then a JOG operation is performed, the motor will jog in reverse.)

Select the jog stop method with I iJ 5 Pi .

Set the jog run frequency to a value other than 0 to execute a jog run.

JSfcP setting

Function

Decelerated stop (Decelerated stop according to the I H t L Tl parameter.)

Coast-stop

DC injection braking stop (Stop according to DC braking parameters set by

dbF I

LdbL.I I

dbfc I )

The jog run acceleration time is set to zero, so setting the JOG run frequency to 5Hz or less is

recommended. If set higher, overcurrent trips may occur, or the motor may not rotate smoothly.

Note) During a jog operation, the LOW and RCH signals will not be output, and PID control will not be

enabled.

- 70