Toshiba Tosvert VF-A5 - Manual (Page 62)

^ ^ (Terminal Selection Parameters)
l b
-
Input terminal selections 0
I b O l b I D
* The relationship between the settings of C f l D d and F f l O d in C r . U t and the valid modes
is given in the following table.
Valid
code
E R D d F R D d Valid mode
A
D ~ 4 D ~ 4
Always valid
C l o i H D ~ 4 Valid when terminal block command input is selected.
F D ~ 4 l o t H Valid when terminal block frequency input is selected.
P D ~ 4 Substitute for panel keys
Note Both terminal block and panel are valid.
* If ST is not selected, the setting will be viewed as ’ | (Same as ST-CC:ON state)
* Up/down frequency setting: The rate of change of the frequency command during up/down contact input
will follow the R C C S d E C E setting values. Therefore, to change the
setting while displaying the output frequency on the LED display, always set
and R E E I R E E E d E E I d E E E . With these
settings, the frequency command value and the output frequency can be
matched, and the up/down frequency can be adjusted while viewing the LED
display.
* Expansion terminal block PCS (optional): The input terminal block normally has 8 contact points, but by
adding the expansion terminal block PCS (optionaO an additional
three points can be added, for a totai of 11 contact points.
* PUSH-type RUN/STOP: Aiways use the PUSH-type RUN/STOP (setting values = 3 q , 3 B) and the
forward/reverse run selection (setting value = H 0) as a pair.
------------> Terminal set to 3 H
r
Run
Stop
-> Terminal set to
3 B
c c
Open; forward mn 6 .
Closed: reverse run
¡/
-> Terminal set to
40
The expansion terminal block PCB is required for PG
input.
Sfi -